Energy Star Application Techniques
Spray application of Energy Star heat reflective paints with airless spray equipment.
Spray application of Rustraint to Corroded Fasteners.
1 Coat Required - Oxygen and Moisture Displacing Rust Encapsulant.
Spray application of Astec Rustraint to corroded fasteners. Rustraint has a high coverage rate of between 10 and 15 m2 per litre as such many of the Accredited Applicators use a conventional spray gun with a 1 or 2 litre pot . This is convenient and can provide up to 30 m2 of coverage from 1 fill and avoids the requirement for set up and clean of an airless spray gun.
Rustraint after application to Corroded Fasteners.
1 Coat Required - Oxygen and Moisture Displacing Rust Encapsulant.
Rustraint applied to corroded fasteners and sections of rust below the solar hot water service. The film of Rustraint penetrates the rust, displaces moisture and oxygen and leaves a full gloss film that is impervious to oxygen and moisture that halts future corrosion.
Rustraint to Corroded Fasteners.
Oxygen and Moisture Displacing Rust Encapsulant.
Corroded fastener fully encapsulated with Astec Rustraint
Rust before the application of Rustraint.
Oxygen and Moisture Displacing Rust Encapsulant.
Corroded cliplock metal roof that has been high pressure cleaned and is ready for the application of Rustraint.
Rust after the application of Rustraint.
Oxygen and Moisture Displacing Rust Encapsulant.
Corroded cliplock metal roof after the application of Rustraint. Rust is fully encapsulated ready for priming.
Spray application of Energy Star AC3 IR Grey Primer.
1 Coat Required - Anti-corrossive bonding primer
Spray application of Energy Star AC3 IR Grey Primer with an airless spray gun. Use a 621 spray tip with an airless that deliivers at lease 3.8 ltrs of product per minute. Spray straight from drum with no added water.
Spray application of Energy Star Metalflex PCM - 1st Coat
2 Coats required - heat reflective protective topcoat.
Spray application of Metalflex PCM with an airless spray gun on a metal roof. Use a 621 or a 623 spray tip with an airless that deliivers at lease 3.8 ltrs of product per minute. Add up to 1.5 ltrs of water per 20 ltr drum of product.
Spray application of Energy Star Metalflex PCM - 2nd Coat
2 Coats required - heat reflective protective topcoat.
Spray application of Metalflex PCM with an airless spray gun on a metal roof. Use a 621 or a 623 spray tip with an airless that deliivers at lease 3.8 ltrs of product per minute. Add up to 1.5 ltrs of water per 20 ltr drum of product.
Spray application close up - 1st Coat
Energy Star Heat reflective topcoat.
Spray pattern close up of a 623 airless spray tip. Overlap during spray should be 50% of fan width which insures full wet cover.
Close up of wet film- 1st Coat
Energy Star Heat reflective topcoat.
Spray pattern close up of a 623 airless spray tip. Overlap during spray should be 50% of fan width which insures full wet cover.
Image of 1st wet Coat.
Energy Star Heat reflective topcoat.
Wet film appearance after spray applivcation with a 623 airless spray tip overlapped 50% of fan width during application. Full wet cover acheived.
